ULTRA-TRANSPARENT | TOTAL TONAL CONTROL | LOW NOISE
MEET THE NEW DISTORTION PEDAL, SAME AS THE OLD DISTORTION PEDAL
Meet the new Orange Distortion pedal, same as the old Orange Distortion pedal — at least that’s how it seems on the outside. After all, apart from the modern tweaks of an added LED and a 9V DC input, this looks like a straight-up reboot of the 1970s relic, right down to its simple type stencilled onto the classic chunky aluminium shell to ape the original units.
Under the hood, though, it’s a different story: the circuitry of the new Orange Distortion has been rebuilt from the ground up, ditching the original’s back-to-back diode design and replacing it with an amp circuit including a tone stack, where bass and mids are preset but treble is user-adjustable via a little trimmer inside the casing.
New design doesn’t mean new sound though — this one comes with all the bite and growl and warmth and howl that you need for that classic 70s amp-like distortion, from vintage crunch to full saturation. With only two dials, for level and depth, but huge versatility, the Orange Distortion can set up your sound for everything from a clean boost to warm and fat gravelly textures to red-hot trebly screamers and maximum saturation. There’s a sweet spot for Jimmy Page-style guitar heroics, and another for Nuggets-style garage rock squall: in fact, every shade of grit and dirt is in there, as long as it’s vintage.
Add in a hardwired switch that’s separate from the PCB and therefore super-easy to service, and you’ve got a vintage pedal fit for the modern age. It’s that level of attention to detail, combined with dedication to an era of crunching power chords that makes the pedal a perfect homage to one of rock’s golden ages, ready to be heard again with fresh ears. It might be a new design, but with the Orange Distortion, the song remains the same.
LOW POWER CONSUMPTION
The Orange Distortion draws very little current (only 3 mA), making it easy to slot into your pedal board’s power supply
A high-quality buffer in the signal chain retains tonal integrity. The Orange Distortion’s buffered bypass takes care of this with its low-impedance buffered bypass switching, retaining your guitar’s full tone.
On the amp circuit’s tone stack, the bass and mids are preset, but the treble is adjustable to taste via a little trimmer inside the pedal’s casing. It’s set in the factory to be a third of the way up, but the user can tweak with ease.
Click here to hear:
Sound clip #1: Distortion Full Gain (Clean Amp)
Sound clip #2: Distortion Medium Gain (Clean Amp)
Sound clip #3: Distortion Low Gain (Clean Amp)
I wanted this to sound better than the original. It’s a lot better used as a boost and a lot better at doing the full distortion sound.
“When I set up the clean sound on the Thunderverb and plugged this Distortion pedal in and turned it on, dude… it was an experience!”
|Features||Low power consumption, buffered bypass, adjustable treble.|
|Controls ( left to right )||Level, Depth|
|Power||9/12 V DC ADAPTER (CENTRE NEGATIVE)|
|Current draw @ 9V:||3 mA|
|Unboxed Dimensions (W x H x D)||9.2 × 7.9 × 12 CM (3.62 × 3.11 × 4.72 inches)|
|Unboxed Weight||388g (13.7oz)|